Find the Source, Fix the Sheathing:
Attic Mold Removal in Lakewood, CO

Two root causes account for most Lakewood attic sheathing mold: improperly terminated exhaust fans and blocked/insufficient soffit-to-ridge ventilation. Both create the same condition — warm moist air in the attic unable to exit, condensing on cold sheathing surfaces. We find which one (or both) is present in your Lakewood, CO attic before proposing any treatment scope.

Sapstain is a common cause of unnecessary attic remediation in Lakewood, CO. We confirm whether staining is active mold or pre-existing sapstain before recommending any treatment — if it's sapstain, we'll tell you and save you the remediation cost.

IICRC guidelines permit in-place treatment of surface mold on structurally sound sheathing — defined as material where structural integrity is maintained (MC below threshold when dry, no physical delamination, no loss of rigidity from fungal digestion). Treatment consists of HEPA vacuuming to remove loose spore material, EPA-registered fungicide application, and penetrating borate for ongoing inhibition. Sections with structural delamination or through-penetration require replacement, assessed individually. Full sheathing replacement across the entire attic is rarely warranted and should require clear justification based on section-by-section structural assessment.

Signs that exhaust fans may be terminating inside your Lakewood, CO attic include: excessive moisture or frost on sheathing near bathroom ceiling locations in winter; mold growth in a pattern that follows the bathroom footprint from above; a bath fan that seems to take a very long time to clear steam from the bathroom; or discovery of flex duct that ends loosely inside the attic rather than connecting to an exterior cap. Our attic assessment includes physically tracing every exhaust fan duct from the fan housing to its termination point — inside the attic or exterior. Improperly terminated fans are among the most common findings we make during attic mold assessments in Lakewood, CO.

We treat wood structural components only — sheathing and rafters — and do not apply products to roofing materials. Our treatment products have SDS sheets available on request, and we can provide these to your roofing material manufacturer representative for verification of compatibility. Most manufacturers don't restrict attic wood treatment by qualified contractors, but if you have a specific manufacturer warranty question, we recommend confirming directly before scheduling work.